MICRO-AIR Artic Air 24 Installationsanleitung PDF herunterladen (Seite 14)

COMPONENT INSTALLATION

Installation of the Condensing Unit

Materials Required

●6 Stainless steel or bronze wood screws

Tools Required

●Marking pencil

●Tape measure

●1/8" Allen key (or hex wrench) for the retaining screws

●Screw driver

●Heat gun, lighter, or propane torch

The condensing unit is comprised of two separate pieces - the main unit and the mounting base,

that are joined together with screws. To minimize the transmission of vibration, the main unit is

not rigidly mounted to the base. Instead, it rests on rubber bumpers which are part of the

mounting base. Four (4) retaining screws are used to prevent the main unit from substantially

separating from the mounting base in the event of a capsize or similar severe angle or jarring.

The retaining screws are not intended to tightly secure the main unit and base. They are simply

there to prevent extreme movement.

To mount your condensing unit:

1. Remove the 4 retaining screws and allow the mounting base to separate from the main unit.

2. Using 6 wood screws or bolts to secure the mounting base in the selected location.

3. Set the main unit onto the base and replace the 4 retaining screws.

Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 62 63

Keine Kommentare

MICRO-AIR Artic Air 24 Installationsanleitung Seite 14